Constructed of ultra-thick high-quality scratch-resistant 1/4" MR10 Lexan Polycarbonate
Cut with Superior CNC 5-axis routher - all edges are super-smooth
Estremely durable - clamps are custom injection molded
Easy to install - no drilling required
Comments: The Kolpin windshield was packed very well and arrived in perfect condition. The assembly was a little more involved than I anticipated, but it went together very well. The instructions are a little vague, but sufficient. The plastic edge molding is applied to the fold joint to seal and eliminate chatter, and it does that very well. The molding seems to roll a little right next to the hinges when the windshield is rotated to the up position. I re-adjusted the hinges and it helped a lot. There is an extra few inches of the molding. I would recommend that you put it on the upper edge where it may contact the hood when it is in the folded position. I was not able to adjust the height to avoid this edge touching the hood when it was down. Even with the edge molding in place, it made a mark on the hood. I am going to put a piece of velcro loop tape on the hood where it makes contact.
Total Reviews (1)
Reviewed by: Thomas09/08/2010 02:58PM
Product ownership: Less than 1 month
Purchased from: Points West Argo
Comments:
The Kolpin windshield was packed very well and arrived in perfect condition. The assembly was a little more involved than I anticipated, but it went together very well. The instructions are a little vague, but sufficient. The plastic edge molding is applied to the fold joint to seal and eliminate chatter, and it does that very well. The molding seems to roll a little right next to the hinges when the windshield is rotated to the up position. I re-adjusted the hinges and it helped a lot. There is an extra few inches of the molding. I would recommend that you put it on the upper edge where it may contact the hood when it is in the folded position. I was not able to adjust the height to avoid this edge touching the hood when it was down. Even with the edge molding in place, it made a mark on the hood. I am going to put a piece of velcro loop tape on the hood where it makes contact.